ASSEMBLY

1. Place the tarpaulin on an even surface
2. Open the sack and turn it upside down. Remove the sack and the two straps. Unfold the bouncy castle with the air inlet towards the back where the blower will be located.
3. Connect the air inlet to the blower and tie it with a strap
4. Close all (one or two) zippers on the bouncy castle
5. Connect the cable to a 220V power outlet and let the blower fill the bouncy castle
6. Anchor the castle using the supplied pegs, one in each corner
7. Inform everybody about the rules and then get going

DISASSEMBLY

1. Clean all dirty surfaces both inside and outside
2. Unplug the cable from the 220V power outlet and disconnect the air inlet. Open existing zippers
3. Let the bouncy castle deflate. Wait a while so that the air is released, the castle is then easier to fold.
4. Fold one third of one side to the centre and beyond. Fold the other side to the centre and beyond. Check that the total width is slightly less than the size (height) of the sack.
5. Roll the castle slowly towards the air inlet (Note! The inlet must not be folded)
6. Use and tighten the two straps around the castle while it lays down on the ground.
7. Raise the castle vertically and put the sack over it. Turn around and you are ready.

CHECK LIST WHEN YOU RETURN IT

1. Cleaned bouncy castle with two straps around it (inside the sack)
2. The folded tarpaulin
3. Air ventilator
4. Bag with supplied pegs, instructions, safety rules (and sometimes an electrical cable),